Names are broken down into the standard parts, DeviceType : Area : Position : Instance (Where needed) : Attribute.
RTD sensors placed on a device, will take the device name specified in the MAD deck.
| ACCL | Used for everything in the RF system that is part of the general physics and operations interface at the cavity level. Also used for penetration |
| GUN | Used for everything in the gun |
| COLL | Used for Collimators |
| WIRE | Used for Fast wire scanners |
| TORO | Used for ICT |
| FARC | Used for Faraday Cup |
| ROOM | Used for Air sensors in tunnel/building |
| LLRF | Used for phase reference line |
| WATR | Water system |
See https://slacspace.slac.stanford.edu/sites/lcls/lcls-2/wd/dsg/Forms/AllItems.aspx, Naming Convention section 6.1.2.2
All AREA field are taken from the document.
Attributes that comprise the physics interface. Scalar unless otherwise specified
| R/W | Name | Description | |
|---|---|---|---|
| R | TEMP | Measured temperature from PLC(degC) | |
| R | FLOW | Measured flow from PLC(GPM) | |
| R | PRLTEMP | Measured temperature from PLC for Phase reference Line(degC) | |
| R | PENTEMP | Measured temperature from PLC for cable penetration(degC) | |
| W | HLIMDES | High limit for interlock Sensor | |
| W | LLIMDES | Low limit for interlock Sensor | |
| W | BYP | Bypass request for interlock sensor | |
| R | BYPSTAT | Bypass readback for interlock sensor | |
| W | RESET | Rest interlock Fault | |
| R | ALARM | Interlock Alarm Status |
Attributes highlighted in Bold will be only present for sensors interlocked for MPS. These attributes in bold will be appended to the temperature or flow signal. eg:
SOLN:GUNB:212:FLOWHLIMDES
SOLN:GUNB:212:TEMPHLIMDES
