Case for: Fast Pulse Test Board Ver00

• Fast Pulser board → PC-144-174-04-R0

Design

• Schematics [pdf][vsdx]
  
• QR Code

Fabrication and Assembly

•  Assembly

  

  

  Note: /\ The two 47[kOhm] resistors /\ have been replaced with x3 1/4[W] 76[kOhm] resistors (had asked for 1/2[W] for 47[kOhm], but only 1/4[W] available 

  

•  I/O

  CASE	PCB	PIN	I/O	Value/ Range[V]	Zener to GND?	Note(s).........................................................................................................................................................................
  	J1	1	In	0/+3.3 TTL	+3.3	Used to generate pulse
  	J2	1	In	0 to 10	+11	Gained up by -10x to set pulse level
  	J3	1	SPLY	+15VDC	+15
  		3	SPLY	-15VDC	-15
  		2, 4	GND	GND
  	TP1		Out	0 to -100		Ideal, really around -90V before pulse
  	OUT		Out	100 to 0		OUT: Solder pad Load with 10nF cap (CM07FD103JO3) to ground Drags out tail-end of pulse Testing done with 1[MOhm] load of scope to COMP Port 1N5624 [Digikey] in parallel with resistor to minimize negative voltage seen relative to COMP Port Note: Offset COMP +1VDC to have the diode clamp around 0V, but if COMP Port is ground, will clamp adequately to protect ASIC load

•  Operation

  If J2 = +10VDC (effects Tp1 & OUT) ← what scales output

  CASE	----- PCB -----
  	[V] J1	PMOS Q1	[V]
  			U1.7	TP1	OUT*	Note(s)
  	0	ON	-15	~0	-5	← Using fast turn on time to generate pulse
  	+3.3	OFF	+15	-90	+85	← _TRIGGER: Normally in this state (otherwise won't work)

  *assumes load resistance to be negligible as it is a cap divider

Info

• SLAC SEDA