This page is intended to serve as a cheat sheet documenting trigger settings for common devices.

CameraLink and PGP Cameras

N.B. Cspad numbers were determined in CXI and worked in XPP.

Febo numbers were determined in XCS.

Camera Model	Pulse Polarity	Pulse Delay	Pulse Width	comments
Adimec Opal 1000	Pos	0.0008	0.0002	Pulse width affects exposure time. 0.0001 sec is too short.
Adimec Opal 4000	Pos	0.0008	0.0002	Maximum trigger rate is 30Hz.
Pulnix TM-6740CL	Neg	0.0006	0.0005	Pulse width affects exposure time.
LBL FCCD	Pos			Pulse width does not affect exposure time. 60 Hz strongly recommended.
Cspad	Neg	5.59092e-4	1e-5
Cspad2x2 Version 1.5 and Daq release after 6.1.1	Pos	5e-4	1e-5	Run trigger the same, 5e-4 seconds, or 59524 ticks in the Daq system. For run triggers coming from controls use 58420 ticks for event code 40, since the controls triggers time from the event code, not event code 140. Start with 11020 runTriggerDelay in the configuration Scan Run Trig Delay in units of 8e-9 seconds to time in or scan across. N.B. the above assumes a Acqdelay of 280. AcqDelay is in units of 1.024e-6 seconds and is in series with the two numbers above.
Febo (normal)	Pos	7.78e-4	1e-6	For normal mode, trigger width not critical
Febo (Average)	Pos	4.41e-4	1e-6	For averaging mode, trigger width not critical
IPIMB	Neg	0.000651824	5e-06

Other Cameras

Camera Model	Pulse Polarity	Pulse Delay	Pulse Width	comments
Timepix	Neg	0.00085	0.0002	Pulse width affects exposure time.

Model	Pulse Polarity	Pulse Delay	Pulse Width	comments
General Standards GSC16AI32SSC (Beam Rate ADC)	Pos			Pulse width is not critical.