ssh ioc-tst-cam5 /reg/neh/home1/paiser/bin/evr.sh EVR=TST:CAM:05:EVR
ssh ioc-tst-cam5
sudo /reg/d/iocCommon/sioc/ioc-tst-cam5/startup.cmd
[paiser@ioc-xrt-xcscam04 ~ 12:18:20] psproc PID USER-ID SIOC COMMAND HOSTNAME PORT 4851 tstioc caRepeater procServ ioc-xrt-xcscam04 30000 5147 tstioc ioc-tst-cam5 procServ ioc-xrt-xcscam04 30001 5150 tstioc ioc-tst-cam5 procServ ioc-xrt-xcscam04 40000
ipmitool -I lanplus -U ADMIN -P <you_should_know> -H ioc-tst-cam5-ipmi power status ipmitool -I lanplus -U ADMIN -P <you_should_know> -H ioc-tst-cam5-ipmi power reset
Where: <you_should_know> is the standard ipmi password that you_should_know...
Python homing script:
/reg/neh/home1/jsludvik/test-python/xip-home.py
XIP main GUI:
/reg/neh/home1/jsludvik/svn/trunk/ioc/xpp/xip_pp/current/motionScreens/xip_gui.sh
XPP motor GUIs:
/reg/g/pcds/package/epics/3.14/modules/pcds_motion/R2.3.4/launch-motor.sh XPP:TST:MMS:01
/reg/g/pcds/package/epics/3.14/modules/pcds_motion/R2.3.4/launch-motor.sh XPP:TST:MMS:02
/reg/g/pcds/package/epics/3.14/modules/pcds_motion/R2.3.4/launch-motor.sh XPP:TST:MMS:03
Startup.cmd:
/reg/d/iocCommon/sioc/ioc-xpp-trigger-ims/startup.cmd
Mode 1: Single pulse
Mode 2: Continuous trigger
Mode 1 and 2 should be the same program, as the Seq will generate the pulses to the motor, and open/close operation shouldn't make any difference whether it is 1 or more. The motor sees a trigger and moves.
This mode is accessed by <PV>:RUN_MODE2
Mode 3: The motor opens on a pulse, counts N pulses and closes on the Nth pulse. The pre-trigger and close trigger should be factored in by the upper layer software to determine the proper N value to put into the motor. All the motor does is, open on N=1, count, then close on N=N.
This mode is accessed by <PV>:RUN_MODE3
Mode 1 was programmed like just mode 2 with a User "Trigger" enable/disable, which may or may not be useful for us. Sort of like 2 layers of enabling, versus just 1 for mode2
This mode is accessed by <PV>:RUN_MODE1
Reset Modes to start new mode:
<PV>:RESET
1) EPICS Motor Record: HOMF
2) Zero Position
3) Move Relative -76.25 degrees
4) Zero Position
Pulse Selector Test/Checkout Procedure (6/10/2013)
X motor calibration
Y motor calibration
New Interlock:
Add Y motor interlock, position >= 2 mm above 0 position, no X movement allowed
X-Y interlock stopped working today, need to investigate.