Pre-Installation

TBD

Installation

Device Installation

Follow the projects device checkout procedure.

Commissioning

Things to Check If 0Hz Capture Rate

On pgpCamTop Screen:

• To big of exposure time, found in Acquisition Settings, is being used
• Image mode, found in Acquisition Settings, is not on Continuous
• Trigger mode, , found in Acquisition Settings, is not on Pulse
• Incorrect RateSel is used, found in Timestamps
  • If drop down is not updating use "MANUAL ENTRY" and enter in the correct Event Code
• Timing:RateType, found in Timestamps, is not on ControlWord
• Timing:Trigger,  found in Timestamps, is not on EVR

On pgpClDiag Screen, found by clicking Rogue pgp Vars.. button on pgpCamTop screen:

• Timing:FidCout/sofCount/eofCount, found in Timing, are not updating
  • Click between Timing and Mini mode typically will solve the issue, may take a second for the Count to start updating again.
• PgpRx/EventBuilder values are not updating when image is Acquiring.
  • Click Reboot Camera button on pgpCamTop screen

Finding Beam on Screen

From the device's camera control screen, pgpCamTop, slowly adjust the Trigger Delay and Exposure time values, in the Acquisition Settings, until beam is found. It is recommended to start with the largest Exposure time without loss of Capture rate, this ranges depending on camera used, then adjusting the Trigger Delay until beam is found. Then dialing in the Exposure time and Trigger Delay from there. If unable to find beam regardless of settings, inform the physicists that the reflection may not be bright enough at the location with the installed target screen.