Attendance:

Agenda/Notes:

  1. Overview of results:
    1. Noise performance with reduced ADC resolution; - remake plots with and without common mode for different rates.
    2. Uniform switching behaviour; - looks good.
    3. Progres on verification;
    4. Any other results so far;
  2. Status of back pressure reduction and running at full rate;
  3. Nolan run through;
  4. ePix-M running parameters (trigger rates, etc); -
    1. Aim for 5160/120 in the ASC, then go up in DAQ trigger.
  5. Beamtime prep
    1. when to set up
      1. Setup non-biasable det soon 
      2. Setup biasable (13th?)
    2. Adding an ePix100 as secondary I0?  Maybe not....just take finer steps in the intensity scan.  
    3. Need to be able to run at 5160/5160.  Rely on previous run-list...just do it at 5160/5160.  AND 5160/2580.  (7C, 3V)
    4. Take different temperature data at 5160/2580 (or 5160/5160):  17C
  6. A.O.B.


Notes:

  • Zongde showed the effect of changing the ADC resolution;
    • Initial findings show that there is a small reduction in noise with reduced ADC resolution,
      • reproduced the plots with and without the common mode correction;
      • We should also
  • No labels