Metrology data
Quality check
X-Y quality check for optical metrology measurements ---------------------------------------------------------------------------------------------------------------------------- segm: S1 S2 dS1 dS2 L1 L2 dL1 dL2 angle(deg) D1 D2 dD d(dS) d(dL) ---------------------------------------------------------------------------------------------------------------------------- segm: 0 38006 38004 -17 -19 41021 41006 35 20 -0.02515 55922 55907 15 2 15 segm: 1 38007 38013 -216 -210 41009 41007 203 201 -0.29760 55918 55911 6 -6 2 segm: 2 38004 38005 -335 -334 41003 41006 310 313 -0.46739 55911 55908 2 -1 -3 segm: 3 38014 38003 -550 -561 41001 41020 506 525 -0.77604 55921 55919 1 11 -19 ---------------------------------------------------------------------------------------------------------------------------- Z quality check for optical metrology measurements ----------------------------------------------------------------------------------------------------------------------------------------- segm: SA LA XSize YSize dZS1 dZS2 dZL1 dZL2 dZSA dZLA ddZS ddZL dZX dZY angXZ(deg) angYZ(deg) dz3(um) ----------------------------------------------------------------------------------------------------------------------------------------- segm: 0 38005 41013 41013 38005 15 -17 -1 -33 -1 -17 32 32 -17 -1 -0.02375 -0.00151 -32.000 segm: 1 38010 41008 41008 38010 -41 -43 -14 -16 -42 -15 2 2 -15 -42 -0.02096 -0.06331 -1.994 segm: 2 38004 41004 41004 38004 13 22 51 60 17 55 -9 -9 55 17 0.07755 0.02638 8.996 segm: 3 38008 41010 41010 38008 113 104 187 178 108 182 9 9 182 108 0.25497 0.16356 -9.055 -----------------------------------------------------------------------------------------------------------------------------------------
Quad location in the hutch
Nagler, Bob <bnagler@slac.stanford.edu> Wed 10/14/2020 2:50 PM Hi Mikhael, Dimitri has the fully fitted position, but very roughly: Looking downstream, it sit behind the target on the Right. Center is at beam height. It is rotated around the vertical (Y) axis ~40degrees. Distance to IP is probably around ~100mm. A very rough sketch of topview below:
2020-10-13-ePix10k-Quad0-calib-Dimitri.pdf
2020-10-13 Geometry validation on data
- geometry file: /reg/g/psdm/detector/alignment/epix10kaquad/2020-10-04-epix10kaquad0/2020-10-04-epix10kaquad0-geometry.txt
- data
- nda-meclv2518-0099-quad0-LAB6-max.txt
- nda-meclv2518-0101-quad0-CeO2-max.txt
- 40 degree tilt around Y is not applied in psana geometry
- X,Y,Z camera offset relative to IP is set APPROXIMATELY in order to get "round" one of the rings on image
References
Overview
Content Tools