2019-05-13 Detector Planning Meeting notes

Single 90 min meeting going forward, rather than two 60min meetings?

ePix Update:

• • Green-liht to TID for following:
    • $60k for parallel ePix10k flipchip bonding run (FY19)
    • $75k to build two new ePix100 detectors (one front-looking, one side-looking), repair the existing compromised units, and store the spare modules against future needs.  Please allocate half of this against 16152-A4001 ePix Support, and the other half against 16158-A4001 Other Detector Support.
    • $5k for an identical copy of the new ePix10k shroud, so that the two 2M cameras will be physically identical.  Please use PA code 16152-A4001 ePix Support for this M&S.
    • $1k for a pair of cases with custom foam for the ePixBig cameras.  Please use PA code 16152-A4001 ePix Support for this M&S.
  • Still to consider:
    
    • $3k for metrology of existing ePixBig (FY19)
    • $25k to formally release ePixBig drawings/models in TeamCenter (FY20)
      
      
  • Testing has begun on ePixHR: Chip is alive and registers can be programmed...more results soon. Rebaseline after we know whether it works.

• SXR requirements doc signed off.

• TES re-baseline document not yet forwarded to LCLS mgmt. I'm late on this.

• Project document for MCP/TImepix is in review with UCB finance. Need to get funding rolling, and to set up a visit to kick this off.
• Costed proposal from UCB received....lots of spending in FY 19 that will be hard to accomplish.
• Are we missing some 10k Smalls?
• Need to conclude the fiber saga.....collect items from Ernesto and TID (timing crate)?
• Status of 'buy' list?

Status:

• RA: Added to 'buy' list....need new base plate ($4k??), stages,
  BIO is in review...
  JF mech design underway
  Wavefront sensor work with Matt Seaburg.
  JF interface document development....where do we want to draw the line? MEC EMP testing CSPAD/ePix Date TBD
• PH: EMP testing confusing, but 10k didn't fall over.
  CSPAD Quad given to TID for isolation/testing as next stage.
  Marc Foster: no obvious solution for fibers.
  ePix10k and ePix100 setup on XCS for software development.
  Paper published in SPIE conference proceedings.
  CSPAD going on eBay....better use??
• KN: Wave8 for FIM CDR 5/30.
  Much NEH crap transport.
  Laser setup this week.
• KZ: Working RIXS CCD procedure.
  ePix10k requires new MPODS, working issue
• Laser SoP moving forward...set up so no laser glasses necessary...administrative controls OK
• eGun interlock doc (2wk.)
• Status documentation/procedures effort
• How many fibers do we have to run to B84?? Work with Jana to tell Mark Foster (2wk)