Search/Navigation:
Related:
SLAC/EPP
/HPS Public
Jefferson Lab/Hall B
/HPS Run Wiki
S30XL-LESA/LDMX
DAQ & Power Mapping in Group C
!!! Remember to make sure the detector is being cooled. !!!
!!! Remember to make sure the interlocks are in the state you want them. !!!
Interlock board: see Group C interlock board for instructions on monitoring and controls.
Serial portserver (Digi Portserver TS 4): 192.168.1.217 on LAN. Telnet from ppa-pc91245, e.g. "telnet 192.168.1.217 2001" will connect you to port 2001. All serial ports are logged to /var/log/portserver on ppa-pc91245. Configure the portserver using its web interface or Telnet. Docs: http://www.digi.com/support/productdetail?pid=1954
Port | Telnet port | Hardware | Useful for |
---|---|---|---|
1 | 2001 | BK 1697 power supply, powering interlock board | resetting interlock board: SOUT000 to turn on, SOUT001 to turn off |
2 | 2002 | ||
3 | 2003 | ||
4 | 2004 |
To be added.
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.