DAQ & Power Mapping in Group C

Maps

DAQ Mapping

Mapping as of 1/19/2015    

1/28/2015

L1t is now FEB 01

L4b is now FEB 15

There are no FEBs mounted for L6t or L6b.

02/01/2015

L6b is now FEB 04

L6t is now FEB 13

Patch Panel Map

Low voltage:

High voltage:

Original high voltage GUI to physical hybrid mapping

link to excel file.

Reloading PGP card drivers

Typically after a reboot we need to reload the pgp card driver. 

$ cd /u1/pgpcard/software/driver_old/

$ ./ pgpcard_load

OLD: Take a calibration run with expert SVT GUI

Start the DAQ:

$ cd /u1/software/software_new

$ source setup_env.csh

$ ./bin/frontEndTestGui

Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.

Make sure the AxiXadc temperature is ok (50-60C).

Configure with config/FrontEndBoardConfigC01.xml

Click <read status> and check that more registers are found.

Turn on power to hybrids (see below)

Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).

Click <Write config>.

Do a soft reset under commands/FebCore/HybridSoftReset.

Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.

Test Run SVT Group C Setup

Group C SVT test setup