Page History

Adimec Opal 1000

Pos

0.0008

0.0002

Pulse width affects exposure time. 0.0001 sec is too short.

Adimec Opal 4000

Pos

0.0008

0.0002

Maximum trigger rate is 30Hz.

Pulnix TM-6740CL

Neg

0.0006

0.0005

Pulse width affects exposure time.

LBL FCCD

Pos

Pulse width does not affect exposure time. 60 Hz strongly recommended.

Cspad

Neg

5.59092e-4

1e-5

Ryan says will change to Pos polarity during shutdown

Cspad2x2
(new firmware only)
version(0xcaff00dd)

Pos

8.65762e-4

1e-5

Version 1.5
and Daq release
after 6.1.1 The new firmware in the Cspad2x2 has moved the integration window
about 300 microseconds closer to the run trigger.  Garth asked that
the integration window start ~5 microseconds before the FEL, so the
measured FEL was about 73900 ticks and that placed the run trigger
at 73305, or 6.15762e-4 seconds.
The acqdelay value from the configuration determines how long after the
run trigger the integration window comes. (AcqDelay * 1.024us)  It takes
6.5 microseconds after the end of acqdelay, so the integration window
starts 6.5 microseconds after the end of acqdelay.  Sven says that
acqdelay of at least 100 microseconds is necessary for the amps to
stabilize if they are being reset.
The DAQ TTL trigger must come after the run trigger and within 5e-4 of
it. Use 2.5e-4 to be safe.
Cspad2x2
Version 1.5

Pos

5e-4

1e-5

Run trigger the same, 5e-4 seconds, or 59524
Run Trig Delay in configuration start with 45720 ticks in the Daq system.
Start with 11020 runTriggerDelay in the configuration
Scan Run Trig Delay in units of 8e-9 seconds to time in or scan across.

N.B. the above assumes a Acqdelay of 280.  AcqDelay is in units of
1.024e-6 seconds and is in series with the two numbers above.

Febo (normal)

Pos

7.78e-4

1e-6

For normal mode, trigger width not critical

Febo (Average)

Pos

4.41e-4

1e-6

For averaging mode, trigger width not critical

IPIMB

Neg

0.000651824

5e-06