...
- Overview of results:
- Noise performance with reduced ADC resolution; - remake plots with and without common mode for different rates.
- Uniform switching behaviour; - looks good.
- Progres on verification;
- Any other results so far;
- Status of back pressure reduction and running at full rate;
- Nolan run through;
- ePix-M running parameters (trigger rates, etc); -
- Aim for 5160/120 in the ASC, then go up in DAQ trigger.
- Beamtime prep
- when to set up
- Setup non-biasable det soon
- Setup biasable (13th?)
- Adding an ePix100 as secondary I0? Maybe not....just take finer steps in the intensity scan.
- Need to be able to run at 5160/5160. Rely on previous run-list...just do it at 5160/5160. AND 5160/2580. (7C, 3V)
- Take different temperature data at 5160/2580 (or 5160/5160): 17C
- when to set up
- A.O.B.
Notes:
- Zongde showed the effect of changing the ADC resolution;
- Initial findings show that there is a small reduction in noise with reduced ADC resolution,
- reproduced the plots with and without the common mode correction;
- We should also
- Initial findings show that there is a small reduction in noise with reduced ADC resolution,