Note: The current in ref-link are without a carrier-board loaded
Currents with carrier-board loaded are close to:
Current[mA]
Anlg
Dig
995
805
Skip to step 10: Assuming optical cable is plugged in correctly
At command prompt:
Code Block
$ cat /proc/pgpcard_0
Scroll up to Lane 0: Should see:
LockLinkReady
1
RemLinkReady
1
Switch port on back of computer...
Power cycle, but if tries of theat does not work...
Lane 0 is hard coded into firmware: Move the optical quad connection in back of the computer & try again
Skipping rest of steps for now to just see if can get camera running...
Assuming Firmware engineer help you get correct version of project downloaded into your local git
Code Block
$ cd IC_projects/epix
# where I have my local git repo
$ git checkout rogue_v5.14
$ git branch
# make sure you see that you're in branch rogue_v5.14
$ git pull
# make sure "Already up to date."
Run GUI: Now that your in correct branch up to date
Code Block
$ cd software/Epix
$ source setup_template.sh
# Starting Rogue --> (rogue_v5.14.0) should show up next to command prompt
$ cd scripts
$ python epix10kaDAQ.py
# actually running GUI