Program
day 12 -swing 12
particle | energy | trigger | events | purpose | mode |
---|---|---|---|---|---|
e | 2.5 | S0+S2+NOSh+NOS3+C1+C2 | 2M | full brem at 2.5GeV - configuration 2 | complete CU scan position 2 up to required statistics |
e | 2.5 | S0+S2+S4+NOSh+NOS3+C1+C2 | 100K | scan CU position 2 | sync with AD, magnet at 600A |
e | 0.5 | S0+S2+NOSh+NOS3+C1+C2 | 25K | e in the CU, CU at 0 degree | make last layer of dump thinner; syn with AD, magnet OFF; check empty events in the CU-CAL |
e | 0.5 | S0+S2+S4+NOSh+NOS3+C1+C2 | 25K | tagged photons from 0.5GeV beam - CU at 0 degree | sync with AD, magnet at 120A, check empty events in the CU-CAL (gammas in the dump?); if nb of empty evts in the CAL is low compete the scan getting 100K evts |
e | 1 | S0+S2+NOSh+NOS3+C1+C2 | 25K | e in the CU | verify new dump position; determine statistics for the following run based on fraction of empty evts in the CAL |
e | 1 | S0+S2+S4+NOSh+NOS3+C1+C2 | 130K | tagged photons position 3 (TBD) |
|
|
|
|
|
| rebuild last layer of dump as it was if needed |
e | 2.5 | S0+S2+NOSh+NOS3+C1+C2 | 10K | direct e in the CU to check beam position | sync with AD, check position of beam |
e | 2.5 | S0+S2+S4+NOSh+NOS3+C1+C2 | 100k | scan CU position 3 (TBD) | sync with AD, magnet at 600A |
e | 2.5 | S0+S2+NOSh+NOS3+C1+C2 | 2M | full brem at 2.5GeV - configuration 3 |
|