Test run cooling plates

Cooling Block	Initial Squareness (<0.050 mm lean at top)	Max Rock (groove/flat - in)	Center Thickness (mm)	Thickness Range (max-min - mm)	Height After Machining at pins (back/front - mm)	Module	Notes
100-1	Pass	0.0005	5.964	0.005	52.451/52.451	Module ?
100-2	Fail - lapped	0.0005	5.972	0.008	52.451/52.451	Module ?	voids in glue?
100-3	Fail - lapped	0.0005	5.997	0.013	52.451/52.451	Module B1
100-4	Pass	0.0005	6.022	0.003	52.451/52.451	Module B3
100-5	Pass	0.0005	6.015	0.005	52.451/52.451	Module B2
100-6	Pass	0.0005	5.961	0.008	52.451/52.451	Module ?	voids in glue?
100-7	Pass	0.0005	5.979	0.008	52.451/52.451	Module T3
100-8	Pass	0.0005	5.966	0.008	52.451/52.451	Module ?	voids in glue?
100-9	Pass	0.0005	5.977	0.010	52.451/52.451	Module T1
100-10	Pass	0.0005	5.964	0.010	52.451/52.451	Module T2

Cooling Block	Initial Squareness (<0.050 mm lean at top)	Max Rock (groove/flat - in)	Center Thickness (mm)	Thickness Range (max-min - mm)	Height After Machining at pins (back/front - mm)	Module	Notes
50-1	Fail - lapped	0.0/0.0	5.977	0.008	50.851/50.851	Module B5
50-2	Fail - lapped	0.0/0.0	5.984	0.010	50.851/50.825	Module T4
50-3	Fail - lapped	0.0/0.0	5.964	0.008	50.851/50.825	Module T5
50-4	Pass	0.0005/0.0005	5.974	0.010	50.825/50.800	Module ?
50-5	Pass	0.0005/0.0005	5.966	0.008	50.851/50.825	Module ?	voids in glue?
50-6	Pass	0.001/0.0005	5.969	0.010	50.851/50.825	Module B4

Search/Navigation: