Module Installation

  1. Connect 28-pin cable (circled in blue) from each input/output module to its corresponding input/output terminal block. 
  2. Connect cable from 15-pin port on PLC module (circled in orange) to 9-pin port on RS232 converter (pictured below). 
  3. Wire positive and negative terminals (circled in green) to those of the Quint Power Supply Unit (pictured below). 

Installing and Connecting Breakout Modules

Connect cable from terminal block on relay module (above) to pinout on relay (below).

Power

  1. Wire the + and - terminals on top of the unit to the 24V and GND Phoenix contacts
  2. The cable from underneath the Quint Power Supply Unit may then be connected to a power source.
  • No labels