• General example
    • Question: Place it hear and hopefully some one will answer after...
      • See this link for details about this question...
  • Setup:
    • DET_BIAS RELATED:
      • Answer place answer in this link: PCB Carrier BRD 
        • Question: What is the typical reverse bias voltage (DET_BIAS) on the substrate?
        • Question: DET_BIAS can change where the common-mode of the pixel is, is this in a good location?
  •  Testing:
    • Back-Plane Pulsing
      • To answers to the following questions:  See Back-Plane Pulsing Q&A section
      • (Q) What is the amplitude of the voltage pulse required to emulate beam-line?
        • (Q) How much charge do we expect tripping to happen at?
        • Beamline Pulse duration?
      • (Q) What is typical bias voltage applied on Detector Bias line to reverse bias the substrate?
      • (Q) At this bias or some known bias voltage what is the expected substrate capacitance for a entire sensor (there are asic 4 in parallel)?
      • (Q) When the beam hits the substrate, which way does the current flow (in/out of pixel front-end) or (assuming substrate is negatively biased) that the current being drawn from the pixel front-end is less/more negative when a pulse hits (positive/negative voltage pulse)?
      • (Q) What is the capacitance vs. bias curve of substrate? 
      • ...
    • Power-Supply Startup-Sequence
      • To answers to the following questions:  See Power-Supply Startup-Sequence--Smalls Q&A section 
      • Cabling
        • (Q) Power and pin requirements met the DC requirement?
        • (Q) Power and pin requirements met the transient response time?
      • Mystery Resistor? 
        • ...
  • No labels