Search/Navigation:
Related:
SLAC/EPP
/HPS Public
Jefferson Lab/Hall B
/HPS Run Wiki
S30XL-LESA/LDMX
Table as of 12/18/2014
GUI FEB # | Physical FEB | DAQ FEB # | Physical Flange Board Channel |
---|---|---|---|
0 | L1t | 0 | FXJY |
1 | L2-3t | 1 | FXJY |
2 | L5t | 2 | FXJY |
3 | L6t | 3 | FXJY |
4 | L4t | 4 | FXJY |
5 | L4b | 8 | FXJY |
6 | L5b | 9 | FXJY |
7 | L6b | 5 | FXJY |
8 | L2-3b | 6 | FXJY |
9 | L1b | 7 | FXJY |
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.