• Recommended Improvements:
    • Holes not on meter side should be moved up to a line with holes on back for easier mounting of PCB
      • Right now centered, should be off-center towards the lid
    • Stand offs on SA, ML, and 3D printed are wrong height and location isn't optimal
      • PN: 2102-440-AL
      • Better location: Plate screws in center, see Example Build: bottom photo
          • ← back
          • ← bottom
          • ← front 
          • ← top
    • 3D printed version
      • Walls are twice as thick, can't use lock washers in cut-in corner, use double-nut and excess solder to keep electrical connection tight
      • Shell of SHV-connector on SA-261-101-32-C00a needs to be tied to ground, use solder lug, its not on ML
        • PN: 031-759
        • Original design counted on case being conductive, 3D version is no
    • Recommend excess soldering on all nuts even if they have a lock-washer to hold in place better
  • 2400 (210V limit)
  • 24XX (230V +/-10 limit)
  • 2410 (1.1kV limit) – typo on drawing, not 11kV limit
  • No labels