Search/Navigation:
Related:
SLAC
/EPP/HPS Public
Jefferson Lab/Hall B/HPS Run Wiki
S30XL-LESA/LDMX
Maps
Table as of 12/18/2014
| GUI FEB # | Physical FEB | FEB S/N sticker | DAQ FEB # | Physical Flange Board Channel |
|---|---|---|---|---|
| 0 | L1t | 7 | 0 | FXJY |
| 1 | L2-3t | 6 | 1 | FXJY |
| 2 | L5t | 11 | 2 | FXJY |
| 3 | L6t | 10 | 3 | FXJY |
| 4 | L4t | 5 | 4 | FXJY |
| 5 | L4b | 8 | 8 | FXJY |
| 6 | L5b | 12 | 9 | FXJY |
| 7 | L6b | 15 | 5 | FXJY |
| 8 | L1b | 9 | 6 | FXJY |
| 9 | L2-3b | 14 | 7 | FXJY |
Patch Panel Map
Low voltage:
| DB44 connector | FEB # | FEB # |
|---|---|---|
| P1 | L1t | L2t |
| P2 | L5t | L6t |
| P3 | L4t | L4b |
| P4 | L5b | L6b |
| P5 | L1b | L2b |
High voltage:
| REDEL connector | FEBs |
|---|---|
| 1 | Top half (top connector) |
| 2 | Bottom half (bottom connector) |
Reloading PGP card drivers
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
OLD: Take a calibration run with expert SVT GUI
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.
Test Run SVT Group C Setup
Overview
Content Tools