**Note: This page will be updated as camera is integrated into DAQ and IOCs are created.
This is a how-to for a single sensor. Ultimately, there will be two of these sensors at qRIXS.
Devices involved:
- Archon controller
- CryoTel controller
- Water chiller (small)
- Sensor with cryotel coldhead
- Laptop (PCxxxxx)
8 cable connections:
- Water lines to from chiller x2
- Glenair signal cable from flange to archon
- 1-to-3 breakout controls cable between CryoTel coldhead/flange and cryotel controller
- On the controller, one connection.
- On the coldhead/flange side, three connections: Two black connectors which go to coldhead, and one db9 connector that goes to the flange.
- Cable that goes from CryoTel controller to coldhead
- Cat5 from Archon controller to laptop
- RS232 to USB cable from cryotel controller (RS232) to laptop (USB)
- Trigger cable to bottom BNC port on Archon
Navigating ArchonGUI:
- Run "./archongui -small" (the -small option allows for a re-sizeable window)
- File → Open → *whatever_name_of_config_file*.acf
- Hit "Connect", "Auto Fetch", "Apply all"
- Turn "Power On" on lower right, this is bias voltage
- In "Slot 3: HeaterX"
- Sensor C should be RTD1000
- Heater A parameters:
- Target: -100C
- Sensor: Sensor C
- Force: unchecked
- Limit(V): 25.0
- P: 50
- I: 1
- D: 10
- IL: 20
- Ramp enable: checked
- Ramp rate: 20mK/tick
- Hit "Apply" (*note: hitting "Apply" will reset any values the PID had accumulated up to that point, like a refresh)
Cooldown takes ~2hrs.
CryoTel Software:
*note: The cryotel has a PID, but we don't use it. We use the other PID (via the Archon) that regulates the heater near/on the sensor. Keeping pwout to a minimum (i.e 60) keeps vibrations to a minimum.
- Open new terminal: sudo putty /dev/ttyUSB0 -serial -sercfg 9600,8,n,1,N
- Commands
- View status: "status"
- Check cooler power: "pwout" (this should be 60. If not, set with "pwout=60")
- Turn cryotel on: "cooler=power"
- Turn cryotel off: "cooler=OFF" (might need to enter this command more than once to actually turn power off)