Table of Conents
Welcome to the interactive map of the first thermomechanical ring prototype at SLAC. You can visit the Cooling Tubes Up map here.
To explore the ring map in interactive mode, use the buttons within the Gliffy diagram macro in the table on the left. You may need to enter full screen. Hover your mouse over the image to get the full screen menu option. Please note that this interactive map only includes loading information. Please visit the Metrology section for the Metrology results.
Heater ID: Quad, batch | #11 | #12 | #13 | #14 | #X | #16 | #17 | #18 | #19 | #20 | Uncertainty | Source |
---|---|---|---|---|---|---|---|---|---|---|---|---|
Length (cm) | ±30 μm | Heaters.xlsx | ||||||||||
Width (cm) | ±30 μm | Heaters.xlsx | ||||||||||
Thickness (μm) | ±5 μm | Heaters.xlsx | ||||||||||
Resistance when wires first bonded (Ω) | ±0.1 Ω | Heaters.xlsx | ||||||||||
Resistance: mounted on ring, before spray painting (Ω) | Heaters.xlsx | |||||||||||
Mass (g) | ± 0.001 g | |||||||||||
Module thickness at center, measured with micrometers (μm) | ||||||||||||
Wire thicknesses, measured with calipers () |
Heater ID | |
---|---|
Before IPA wash & dry rag polish | |
After IPA wash & dry rag polish | |
Comments |
Heater ID | |
---|---|
Load date | |
Load position | |
Shim testing results | |
Expected glue layer thickness (μm) | |
100-μm shim | |
200-μm shim | |
Glue batch | |
Syringe ID | |
Date dispensed | |
Dispensing | |
Estimated glue mass per star (mg) | |
Averaged mass tests | |
Time elapsed since syringe fully thawed | |
Minutes module held under vacuum (Hold time) |
Link to slides showing results of heater x,y measurements https://docs.google.com/presentation/d/1ZdiT7JzgxqH46K8tOTxdChammp0vxplUcT0MfgkjaGo/edit?usp=sharing