Prepare

• Verify power off.  (MPOD panel or IoC panel)
• Install detector in Marietta.
• Connect chiller, start flow.
• Connect data fiber.
• Connect gas line if applicable, start flow at 5l/m.

Power

• Set known values on mpod.
• Pin out cable according to diagram.
• Turn off mpod.
• Connect power cable to detector.
• Set operating voltages on mpod. (check here)
• Start DAQ ("restartdaq") and configure to begin idle.

Thermally Stabilize

• For 10k small/100: Wait for temperature < 10C and humidity < 10% (ideally under 5%)
• For 10k2M: takes ~1hr 

Record Voltage/Current/Temperature Values

Measure Pedestals (run charge injection script)

Collect Fluorescence Data

• Make sure centers line up (detector and target)
• Take pedestals if you haven't already
• Silver: ~10cm distance, 35kVp, 45uA (50 was old current, proved to be too high, saw burn-in)

Direct Illumination w/Mini-X

Process Data

Update Traveller