Geometry

Status:

• Overlap of top tiles
  Updated to go in the correct direction (thanks Joanne). Consequence was that the modeling of the ribbons on the top was modified causing the need to update some code in AcdRecon and AcdUtil.
• Curvature of the top tiles has been implemented in a more recent tag of xmlGeoDbs (thanks Joanne)
  This needs to be tested and the digitization and active distance calculations updated to accomodate the new volumes in the geometry.

To Do:

• Cross check the placement of the tiles and ribbons against the integration testing position maps.
  When will data be available?

• Update Blanket/MMS
  Dave Thompson has provided the final numbers
  Currently the blanket/MMS is simulated as a single layer of cooked up material. Do we desire a more accurate representation? The cost being multiple layers to propagate through in the simulation.

• Screws
  Typical tiles have four iron screws each, the bottom row large tiles have 20 (I think). Much work went into this before DC2. However, there were problems in how the volumes associated with the screws were handled by the simulation. Joanne has volunteered to address this again and basically start from scratch.

• Shingling
  Work on this has not been scheduled.

• No plans for modeling flexures, BEA, or updating the simulation of the support material.

Digitization

• Ribbon Attenuation

Reconstruction