Introduction

There are three periods of test beams in which 3D sensors will be tested at CERN. This page contains a placeholder for notes/reminders for preparation.

MCC board

• General tests (Pelle & Alessandro)

BAT

• List of tests to be carried out before using (Pelle & Alessandro)

10-17 October

DUT's

• List of devices under test
  • STA-3D (2E,3E and 4E?)
  • CNM
  • SINTEF
  • FBK (irradiated?)

EUDET Telescope

• Hardware modifications on TPLL
  • TPLL boards from Oslo and Manchester are modified
  • If we use the MCC board only one (with some backup perhaps) needs to be modified
• Software changes
  • Minor modification for the Oslo reconstruction code (Ole)
  • Need to modify the BAT online monitoring if we use the MCC board.
• Mount for devices
  • How many devices can fit in the telescope

Run plan

Should focus on measurements that require the extra resolutions

• Charge sharing
• Electrode charge collection efficiency

24-04 November

This assumes that we have access to the Morpurgo magnet.

DUT's

• List of devices under test
  • STA-3D (2E,3E and 4E?)
  • CNM
  • SINTEF
  • FBK (irradiated?)
• Mounting
  • Prefered choice: Use the cooling box from May even if there is no required cooling
  • If irradiated sensors are used then we need to verify the cooling in the box (Anyone?)
  • The May cooling box could hold only 4 DUTs, using MCC it is easy feasable to test at least 8
    • Need new box/mounting

Run plan

Should focus on the measurements to validate the 3D performance and fill in the information we are lacking from the May TB.

• Angle scan
• Magnetic field strength scan

20-25 November

This period is in H6 without magnetic field.

DUT's

• List of devices under test
  • STA-3D (2E,3E and 4E?)
  • CNM
  • SINTEF
  • FBK (irradiated?)
• Mounting
  • Same comments as above.
  • Irradiated sensors should be available, see earlier comments on mounting

Run plan