Search/Navigation:
Related:
SLAC/EPP/HPS Public
Jefferson Lab/Hall B/HPS Run Wiki
S30XL-LESA/LDMX
This page documents the mapping of the slow control channels between the flange board and a RTM. The "top", "bot" naming convention refers to the setup at SLAC as shown in the picture below\
RTM qsfp labeling convention is: A,B,C,D from left to Right
Flange board labeling convention is 0,1,2 from left to right, i.e. from board ID to QR code
This table shows the FEB channel links mapping. No dead links were found.
Pair | A0 | A1 | A2 | B0 | B1 | B2 | C0 | C1 | C2 | D0 | D1 | D2 |
---|---|---|---|---|---|---|---|---|---|---|---|---|
RTM TOP (S/N C03-02) | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 | 11 | 10 | 9 |
RTM BOT (S/N C03-01) | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 | 11 | 10 | 9 |
RTM DEV (S/N C03-04) | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 | 11 | 10 | 9 |
Check on the qfsp connectors:
Q0 C03-01 in D Slot: D0 D1 D2 → 11 10 9
Q1 C03-01 in D Slot: D0 D1 D2 → 11 10 9
Q2 C03-01 in D Slot: D0 D1 D2 → 11 10 9
Q3 C03-01 in D Slot: D0 D1 D2 → 11 10 9 (This Qfsp gave some issues on D2. After couple of power cycles of the feb I was able to get the link established)
Q4 C03-01 in DSlot: D0 D1 D2 → 11 10 9
Currently:
Q0 is the one with the plastic pull tab
Q1 is in TOP A
Q2 is in TOP B
Q3 is in TOP C
Q4 is in TOP D