You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

This page documents the mapping of the slow control channels between the flange board and a RTM. The "top", "bot" naming convention refers to the setup at SLAC as shown in the picture below\




RTM qsfp labeling convention is:  A,B,C,D from left to Right



Flange board labeling convention is 0,1,2 from left to right, i.e. from board ID  to QR code




This table shows the FEB channel links mapping. 

PairA0A1A2B0B1B2C0C1C2D0D1D2
RTM TOP (S/N C03-02)87654321011109
RTM BOT (S/N C03-01)8765432101110

9

RTM  OLD (S/N C03-04) 87654321011109


Check on the qfsp connectors:
Q0 C03-01 in D Slot: D0 D1 D2 → 11 10 9 
Q1 C03-01 in D Slot: D0 D1 D2 → 11 10 9 
Q2 C03-01 in D Slot: D0 D1 D2 → 11 10 9
Q3 C03-01 in D Slot: D0 D1 D2 → 11 10 9 (This Qfsp gave some issues on D2. After couple of power cycles of the feb I was able to get the link established)
Q4 C03-01 in DSlot: D0 D1 D2 → 11 10 9 


  • No labels