Search/Navigation:
Related:
SLAC/EPP
/HPS Public
Jefferson Lab/Hall B
/HPS Run Wiki
S30XL-LESA/LDMX
!!! Remember to make sure the detector is being cooled. !!!
!!! Remember to make sure the interlocks are in the state you want them. !!!
To be added.
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.