Group C SVT Setup

HPS 2014 SVT Group C Setup

All operations are from hpstracker in group C.

Operation

!!! Remember to make sure the detector is being cooled. !!!

!!! Remember to make sure the interlocks are in the state you want them. !!!

SVT EPICS Power Instructions

Basic instructions to take a pedestal run with CODA

To be added.

MPOD Power Map

Table as of 11/17/2014

GUI FEB ID	Physical FEB	Status	Comment
0	L1t	OK
1	L2-3t	OK
2	L5t	OK
3	L6t	OK
4	L4t	OK	These should be checked!
5	L4b	OK	These should be checked!
6	L5b	OK
7	L6b	DIG bad (Y-cable problem?)
8	L2-3b	OK
9	L1b	Short on AVDD?

GUI Flange ID	Physical Flange Board	Status
0	1 (top)	OK
1	2	OK
2	3	OK
3	4 (bottom)	OK

Reloading PGP card drivers

Typically after a reboot we need to reload the pgp card driver.

$ cd /u1/pgpcard/software/driver_old/

$ ./pgpcard_load

OLD: Take a calibration run with expert SVT GUI

Start the DAQ:

$ cd /u1/software/software_new

$ source setup_env.csh

$ ./bin/frontEndTestGui

Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.

Make sure the AxiXadc temperature is ok (50-60C).

Configure with config/FrontEndBoardConfigC01.xml

Click <read status> and check that more registers are found.

Turn on power to hybrids (see below)

Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).

Click <Write config>.

Do a soft reset under commands/FebCore/HybridSoftReset.

Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.

Test Run SVT Group C Setup

Group C SVT test setup

Search/Navigation:

Related: