Documentation

NLCTA Proposal: version 1 2

Slides from Takashi on checking Gaussian approximation with EGS simulation - link

Collimator scattering at JLab - link

NLCTA beam test slides from Pelle - link

Beam parameters - 500um beam spot

Beam parameters - 150um beam spot

Operation

Log book

9/29/2013

9/30/2013

DAQ Desktop Setup

IP address: 172.27.244.72

ttyS0: ibootbar
ttyUSB0: BK
ttyUSB1: keithley

Power Supply Operation

dataprobe iBootbar

Manual

1. old three-output
2. BK
3. keithley
4. PC
5. monitor

Serial: 115200 8N1

Common commands:
"get outlets" - list all outlets
"get outlet X" - list outlet X
"set outlet X on/off/cycle" - turn on/off/cycle outlet list outlet X

Keithley 2400

Manual
Serial: 9600 8N1

Common commands:
"measure?" - returns [voltage, current, ]
"source:voltage?" - returns voltage
"source:voltage 10" - set to 10 V
"output on" - output on
"output?" - returns 1 for on, 0 for off
"source:voltage:range up/down" - change range for voltage setting

BK Precision 1697

Manual
Serial:

Common commands:
"SOUT000" - enable output
"SOUT001" - disable output
"VOLT00XY.Z" - sets voltage to XY.Z Volts

Lab prep

GIMP current vs bias

460V-5.2uA (minutes to get down that low and still decreasing)
500V-5.7uA-3.6uA (20mins)