Notes:
- If on a PAMM - set camera to free run
Camera | Motor positions for checkout | Conditions/Notes | Reference Image |
---|---|---|---|
DTOTR2 CAMR:LI20:107 | DTOTR_X: XPS... = -46.5 DTOTR_Y = 144 | Exposure = 0.01s / Filter out Dump table lights on You should be able to see the damage on the YAG2 screen, and the upper/lower edges of the holder should be sharp. The sides of the image will be out of focus since the screen is rotated 45degrees. Note - Retract DTOTR1 or it will make a shadow on the DTOTR2 image | |
DTOTR1 CMOS:LI20:3505 | DTOTR_X/Y as above DTOTR1_X = 24 DTOTR1_Y = 98 | Exposure = 0.1s / Filter out Same as above. You should be able to see damage markings on YAG2. Move the DTOTR1_Y mover in 5mm steps to find features. | |
LFOV CAMR:LI20:301 | LFOV = 150 XPS:LI20:MC01:M6 | Exposure = .001 / Filter = out The stuff on the left is LBG_LFOV. Use LBG_LFOV motor to retract (to left) | |
GAMMA1 CAMR:LI20:302 | Exposure = .01s | ||
GAMMA2 CAMR:LI20:303 | |||
CHER CAMR:LI20:308 | |||
PRDMP CAMR:LI20:108 | |||
EDC_SCREEN CAMR:LI20:309 |