Search/Navigation:
Related:
SLAC/EPP
/HPS Public
Jefferson Lab/Hall B
/HPS Run Wiki
S30XL-LESA/LDMX
DAQ mapping as of 12/18/2014
GUI FEB # | Physical FEB | FEB S/N sticker | DAQ FEB # | Physical Flange Board Channel | High Speed Cable # |
---|---|---|---|---|---|
0 | L1t | 7 | 0 | F0J1 | 1 |
1 | L2-3t | 6 | 1 | F0J2 | 2 |
2 | L5t | 11 | 2 | F0J3 | 3 |
3 | L6t | 10 | 3 | F1J1 | 4 |
4 | L4t | 5 | 4 | F1J2 | 6 |
5 | L4b | 8 | 8 | F2J3 | 9 |
6 | L5b | 12 | 9 | F3J1 | 10 |
7 | L6b | 15 | 5 | F3J2 | 11 |
8 | L1b | 9 | 6 | F2J1 | 7 |
9 | L2-3b | 14 | 7 | F2J2 | 8 |
Flange to FEB Mapping (12/18/2014)
Picture of physical FEB mounting (Jan 14th 2015)
Low voltage:
DB44 connector | FEB # | FEB # |
---|---|---|
P1 | L1t | L2t |
P2 | L5t | L6t |
P3 | L4t | L4b |
P4 | L5b | L6b |
P5 | L1b | L2b |
High voltage:
REDEL connector | FEBs |
---|---|
1 | Top half (top connector) |
2 | Bottom half (bottom connector) |
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.