**Note: This page will be updated as camera is integrated into DAQ and IOCs are created.
RIXS-CCD Controls and Interlock Scheme (from 11/30 meeting with controls/DAQ)
Meeting with Patrick/Kaz/Bhavna (2/22):
- Cryotel IOC (Patrick's update)
- IOC screen has PID controls, but since we only use PID in archon, that section will be wiped before we give this to users
- For cryotel screen:
- Hit only POWER mode: constant cooling, 60W
- ON mode aka temperature mode: uses PID to get there
- 3/8" tubing for chiller, raise flow rate
- Software wise, everything is in place (trigger from the archon, timing, etc)
- RIX:STA:CCD:01 as the base name for the PVs
This is a how-to for a single sensor. Ultimately, there will be two of these sensors at qRIXS.
...
- If frames aren't updating, it's a trigger issue.
- How to save data: NO TILDES, e.g. “/home/bnayak/test" and data gets saved as “test_4800x300_xx.raw” where xx is the frame count
- Detector constantly running, "Save Sequence" just determines how many get data files get written
- Make sure temperature is actually at the target temp (DO NOT CLICK ramp enable)
...
- )