...
- Waveform: Pulsed mode
- Frequency: 200Hz (or anything under 250Hz)
- Pulse Height: 3.3V
- Pulse Offset: 1.65V
- Pulse Width: 1us
- Burst Mode: ON (lately it seems you must have it on to see anything on detector)
Turning things off (warming up CCD):
- Turn cryotel off (cooler=off)
- Turn bias voltage off (power off on gui)
- Set target temp to +10C
- That's it
Troubleshooting issues and lessons learned:
- If frames aren't updating, it's a trigger issue.
- How to save data: NO TILDES, e.g. “/home/bnayak/test" and data gets saved as “test_4800x300_xx.raw” where xx is the frame count
- Detector constantly running, "Save Sequence" just determines how many get data files get written
- Make sure temperature is actually at the target temp (DO NOT CLICK ramp enable)