Page History

...

The -s specifies the serial number used (00000000 is the default one for Optoboard V2.1), -G is the link number of FELIX and -d the FELIX device. If -s  is set to 00000000 and -v 1.3, optoboard_felix sends the parameters in the config ~/optoboard_felix/configs/optoboard_lpgbtv1_gbcr2_vtrxv1_3_default.json to the lpGBTs, GBCR and VTRx+. Check the FELIX documentation or the optoboard_felix readme for more information on this.

If you do flx-info link you should see that respective link aligned. If you do flx-info podpower you should see something like this (if single Optoboard outside test-Optopanel is connected similarly:

Optical power (Receive=RX or Transmit=TX) of channel in uW:
        |     0   |     1   |     2   |     3   |     4   |     5   |     6   |     7   |     8   |     9   |    10   |    11   |
        |=========|=========|=========|=========|=========|=========|=========|=========|=========|=========|=========|=========|
 1st TX |  983.30 |  986.10 |  892.10 |  970.00 |  937.50 | 1009.70 |  916.20 |  970.30 |  920.00 |  960.80 |  924.40 |  958.50 | 
 1st RX |  946.80 |  790.20 |  870.50 |  761.80 |    0.00 |    0.00 |    0.00 |    0.00 |    0.00 |    0.00 |    0.00 |    0.00 |

After fibre fanout installation:

After the fibre fanout is installed, configuring the Optoboards will look similar to this:

...

*after power-up and inside the test-Optopanel with 9.0 V supplied. If powered outside the test-Optopanel directly on the connector with 2.5 V expect a current ~415 mA.

Connectors:

Check the above interfaces document for more detailled description.

...