...
3a) Trigger based on a Destination receiving Beam1MHz + Include Dest
Rate Mode = Fixed
Fixed Rate = 1MHz
Destination Mode = Include
Destination Mask = Dest Bit
Ch Enabled → Only when you are done configuring, to avoid high undesired triggers on your device!
This will trigger your device in either Fixed rate or AC Rate beam, anytime there is beam.
3b) Trigger based on Destination and Particular Rate (Device Rate Limited)
Fixed Rate
AC Rate
3c) Trigger based on a particular rate but no destination requirement
AC and/or Fixed Rate at a Lower rate than beam rate with Destination Requirement
Fixed Rate Case:
Rate Mode = Fixed
Fixed Rate = 10Hz
Destination Mode = Include
Destination Mask = Dest Bit
Ch Enabled → Only when you are done configuring, to avoid high undesired triggers on your device!
AC Rate Case:
Rate Mode = AC
AC Rate = 10Hz
Destination Mode = Include
Destination Mask = Dest Bit
Ch Enabled → Only when you are done configuring, to avoid high undesired triggers on your device!Dest Mode = Don't Care
3c)Trigger based on AC and/or Fixed Rate at a Lower a Lower rate than beam rate withOUT Destination Requirement
Fixed Rate Case:
Rate Mode = Fixed
Fixed Rate = 10Hz
Destination Mode = Don't care
Ch Enabled → Only when you are done configuring, to avoid high undesired triggers on your device!
AC Rate Case:
Rate Mode = AC
AC Rate = 10Hz
Destination Mode = Don't care
Ch Enabled → Only when you are done configuring, to avoid high undesired triggers on your device!
3d)
Trigger on special bits like the Calibration Bit for BPMS → Control Sequence Setup
...
Trigger on a BSA Buffer at 1Hz, 10Hz, 100Hz → Control Sequence SetupA) For a specific area
