...
...
...
1) Access the timing trigger displays
...
$TOOLS/pydm/display/evnt/tprDiag.ui & $TOOLS/pydm/display/evnt/tprDiagExp.ui
2)General TPR Setup:
2a) Make sure the MODE PV is set to SC, Link is up and set the Message Delay
...
Q1) Do you need to trigger when a Destination is included?
LASER0X1
DIAG00X2
DUMPBSY0X4
DUMPHXR0X8
DUMPSXR0X10
LESA0X20
Q2) Do you need to trigger at a Lower Frequency?
...
Q3) Do you have a special trigger, like a Calibration, Kicker or BSA BUFF?
The SECTIONS of Channel setup are organized by column and repeated by row (x15 configurable channels)
Rate Mode can be Fixed, AC or Seq
Fixed Rates are 1Hz, 10Hz, 100Hz, 1KHz, 10KHz, 71.5KHz and 1MHz (929KHz) - If different, you are loading the wrong db!
AC Rates are 0.5Hz, 1Hz, 5Hz, 10Hz, 30Hz, 60Hz → To achieve 120Hz INCLUDE TIMESLOT MASK TS3 and 6!
Exp Rate → THIS SECTION NEEDS EDITS! Apologies...
Dest Mode= Inclusive, Exclusive or Don't care
Dest Mask = Enter Destination bit
...
3a) Trigger based on a Destination receiving Beam
...
