Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The calibration unit (CU)

Image Added
Flight Hardware : TKR (FM8) & CAL (FM101) on bay 3 (close to the edge) and CAL (FM109) on bay 1.

We took photos from arrival and installation in the clean room.

Summary of Results

The CU is different from the LAT in many respects, so is the software to run it. There is essentially only a single local installation allowing to run the CU, right now, and it resides on the lat-btserver  - latbt01/lat-bt04 (spare) machines. Here are some notes about the installation itself, the tests that can be performed, the schema files to be used.

 We took photos from arrival and installation in the clean room.

Flight Hardware : TKR (FM8) & CAL (FM101) on bay 3 (close to the edge) and CAL (FM109) on bay 1.

No modifications were done or rework on towers during the beam test. During integration into the 1 x 4 grid one TKR connector (between flex cable 7 and the TEM) of non-flight TKR was slightly offset and we added a connector saver to avoid stress in the cable.

...