...
| Run | Start | End | Event | Particle rate | Tilt | Comments |
|---|---|---|---|---|---|---|
| 653 | 1:50 | 2:05 | 4852 | 40 | 0 | Ended to try new version of producer |
| 683 | 3:22 | 3:55 | 9906 | 40 | 0 | (eventNumber offset -1, new version of YarrProd still can not sync with MIMOSA) |
| 684 | 4:00 | 4:34 | 9908 | 40 | 0 | ((eventNumber offset 0, new version of YarrProd still can not sync with MIMOSA) |
| 686 | 4:49 | 5:20 | 9908 | 40 | 60 | (x increase 5 mm) |
| 687 | 5:23 | 5:56 | 9928 | 40 | 60 | same running condition as 686. Suddenly found YarrProd sync with MIMOSA, so, maybe run 684 and 686 also sync. |
| 688 | 5:58 | 6:05 | 2338 | 40 | 60 | (Not sync, so, looks like 687 just accidently sync) |
tilt photo for run 686,687
7:40 stop testing A97, replace with B53.
7:59 starting with the Tuned chip config file from LBNL for beamtest. B53 hase tens of very hot pixel. Need to mask the hot pixel.
~8:20, shut down beam to run quick digital/analog/thresold scan. The analoy scan pick out all the hot pixel and automaticly mask them out.
8:54, beam test with the new config file, looks like most of noisy pixel are quiet now.
| Run | Start | End | Event | Particle rate | Tilt | Comments |
|---|---|---|---|---|---|---|
| 714 | 8:54 | 9:02 | 2107 | 35 | 0 | noise pixel masked, stopped because of beam change |
9:03 beam change, so no beam for ESA. Beam is expected to be back after ~15mins
stop at 9:24.