Versions Compared

Old Version 91

changes.mady.by.user Dong Su

Saved on

compared with

New Version 92

changes.mady.by.user Dong Su

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Started Run 751, -36C, Ileak=340uA. Moved Yfine up by 4mm but moved more like 8mm. This run covers X=(42 - 62). 12K events. The histogram save for this didn't work. I rushed starting next run before this was complete ?         
  • Started Run 752, -34C, Ileak=380uA. Move Yfine back -4mm to recover the last strip X=(30 - 50). 12K events.
  • 17:20 MCC called asking to taking beam to full 120Hz to primary expt briefly. Ended run 752 with ~5K events. Missing saving histogram.
  • 17:26 They returned faster than I thought. Run 753 continue with same setup as last run. End with 7.5K events.
  • 17:52 Run 754: Yfine +4mm back to X=42-62 strip again. Ended wtih 9K events.
  • 18:26 Run 755: Yfine +4mm to the final strip X>60. Ileak=480uA. Tgas=-31C.   
  • Access to swap in LUB2 since it looks like the LUB2 runs missed beam spot. Took out the wood chip to get block in contact to dry ice partition and sprayed some dry ice from chamber to DUT chamber. Moved HV control back to Bertan remote control. DUT box Xfine shifted x+28mm to compensate for the removed wood chip. Whole Caladium dropped 2mm to allow beam seeing full DUT height. 
  • Operator told me no more beam after 9pm. LCLS going to low E. There might be chance for intermitant beam tomorrow afternoon.
  • 20:50 Gas temperature is dropping very slowly and only reached -26C. Can get HV to 600V but ran out of time to locate beam spot and they are changing beam energy already at 8:55pm. Looks like this is it for the cold run. Out of beam and out of dry ice.   
  • No beam until at least tomorrow afternoon.
  • Access to dismount the cooling box and putting LUB2 back to the freezer in ESA. DUT rotational stage back on with RTISC4A mounted for possible more beam session. LV=2.0V and fully powered current=0.3A. HV=-80V (reading -86V) and bias current = 1.6mV = 0.16uA. Created a new module type RTISC4A using Seigei's script duplicate.sh to copy from fei4bexample. Threshold calibration from the clone shows large noise and large threshold dispervision. A quick attempt of tuning with fasttune-3000e-10Tot16ke-noisemask.pl got stuck with `subsription disconnected'. Leave this to Martin.