...
Drawings are created from CU-ISC and OSC I-DEAS models combining design dimensions with final setup measurements, than they are translated to pdf, dxf and other formats.
CU/ISC 2D DRAWINGS
ACD
...
TILES position (2D drawings)
Drawings created combining Moiseev-Ylinen and INFN-Pisa Team measurements.
PDF version:
CU-ISC_setup_test_config_ACD_Tiles_position_2D.pdf
DXF version:
...coming037xx-003-001_CU_ACD_TILES_POSITION.dxf
NOTES
see also ACD tiles photos and dimensions at Geometry
...
CALs-Trackers and Theodolite Targets position (2D drawing)
Targets and Instruments distances taken are given with respect to ISC base plate -X/-Z borders.
CALs distances are measured wrt CsI layers (see note below).
| No Format |
|---|
CALs distances IMPORTANT NOTE:1) Consider that each CsI crystals has a |
...
wrapper around 0.75mm thick. This |
...
wrapper thickness must be subtracted to have the exact distances |
...
. Hext (CsI layer height)=21.34mm Hint (CsI crystal height)=19.9mm DH=Hext - Hint=1.44mm --> wrapper thickness=0.72mm 2) At each crystal end there are both gap and endcap. The gap+endcap length is around 6mm (the length is variable reffering to NLR drawings, link below) Lext (CsI layer length)=338mm Lint (CsI crystal length)=226mm DL=Lext - Lint=12mm --> gap+endcap length=6mm
|
PDF version:
037x7-001-001CU_Theodolite_TARGETS-INSTRUMENTS_POSITION.pdf
DXF DXF version:
037x7-001-001CU_Theodolite_TARGETS-INSTRUMENTS_POSITION.dxf
coming...
NOTES:
CAL CsI crystals drawings can be found here: NRL CALs drawings
...