INTRODUCTION
In On this page I'm uploading 2D/3D drawings of the CU-ISC and OSC configurations.
...
Drawings are created from CU-ISC and OSC I-DEAS models combining design dimensions with final setup measurements, than converted they are translated to pdf, dxf and other formats.
CU/ISC 2D DRAWINGS
ACD
...
TILES position (2D drawings
...
)
Drawings created combining Moiseev-Ylinen and INFN-Pisa Team measurements
...
.
PDF version:
CU-ISC_setup_test_config_ACD_Tiles_position_2D.pdf
DXF version:
037xx-003-001_CU_ACD_TILES_POSITION.dxf
NOTES
see also ACD tiles photos and dimensions here:
THEODOLITE TARGETS POSITION 2D drawing
PDF version:
at Geometry
CALs-Trackers and Theodolite Targets position (2D drawing)
Targets and Instruments distances are given with respect to ISC base plate -X/-Z borders.
CALs distances are measured wrt CsI layers (see note below).
Panel |
---|
CALs distances IMPORTANT NOTE: 1. Consider that each CsI crystal has a wrapper around 0.75mm thick. This wrapper thickness must be subtracted to have the exact distances. Hext (CsI layer height)=21.34mm Hint (CsI crystal height)=19.9mm DH=Hext - Hint=1.44mm --> wrapper thickness=0.72mm 2. At each CsI crystal end there are both gap and endcap. Lext (CsI layer length)=338mm Lint (CsI crystal length)=226mm DL=Lext - Lint=12mm --> gap+endcap length=6mm |
PDF version:
037x7-001-001CU_Theodolite_TARGETS-INSTRUMENTS_POSITION.pdf
DXF version:
037x7-001-001CU_Theodolite_TARGETS-INSTRUMENTS_POSITION.dxf
NOTES:
CAL CsI crystals drawings can be found here: NRL CALs drawingsCU-ISC_Theodolite_TARGETS_POSITION_2D.pdf
CU/ISC 3D DRAWINGS
The following CU/ISC 3D drawings can be viewed (not measured) with Acrobat Reader 7.08.
...