...
Counts/rev
1 motor revolution = 
mm
=> 20000*1.27 = 25400>4098.36065* =
Stepper Resolution
2000
Parameters that affected in lowering the chriping noise Other Parameters (starting point)
Running current = 0.5A
Holding current = 0.2A
Stepper Damping Cut off = 150
Max Speed
X axis maximum speed attained mm/sec
Error Thresholds
InPositionDistance (the position error threshold below which an axis is considered to be in position) for both axis 10-5 mm
InPositionTime (quantity of time that the position error of the axis must be less than InPositionDistance) = 500 sec
PositionErrorThreshold ( maximum allowable position error (the difference between the position command and the position feedback) before a position error fault is generated.)
1mm
Profile Monitor X axis
Counts/rev
1 motor revolution = say 5000 microsteps
Counts/unit
In Aerotech for mm as unit
1 motor revolution = mm
=>5000/
Stepper Resolution
2000
Other Parameters (starting point)
Running current = 0.5A
Holding current = 0.2A
Stepper Damping Cut off = 150
Max Speed
/secY axis maximum speed attained 0.75mm mm/sec
Error Thresholds
InPositionDistance (the position error threshold below which an axis is considered to be in position) for both axis 10-5 mm
InPositionTime (quantity of time that the position error of the axis must be less than InPositionDistance) = 500 0 sec
PositionErrorThreshold ( maximum allowable position error (the difference between the position command and the position feedback) before a position error fault is generated.)
...
