Procedure for use (alignment, operation)installation
- Install sample holder hexapod (usually already installed)
- Install VISAR assembly platform (grey rectangular in the figure, make sure the front-round side touching the hexapod base)
- Install the limiting fingers (two green squares in the figure) on Q0 and Q1 assembliesÂ
- Push the breadboards of Q0 and Q1 such that it lines up with the back and side of VISAR breadboard.
- Bring Q2 assembly close to the Q1 assembly by setting a wedge block (red color block between Q1 and Q2 assembly in the figure). Follow the comment in the figure.
- Bring Q3 assembly close to the Q0 assembly and set it against hexapod base and VISAR assembly. (red color block between VISAR assembly and Q3 assembly in the figure).