Search/Navigation:
Related:
SLAC
/EPP/HPS Public
Jefferson Lab/Hall B/HPS Run Wiki
S30XL-LESA/LDMX
Page History
Maps
DAQ Mapping
MPOD Power Map
Table Mapping as of 111/1719/2014
| GUI FEB ID | Physical FEB | Status | Comment |
|---|---|---|---|
| 0 | L1t | OK | |
| 1 | L2-3t | OK | |
| 2 | L5t | OK | |
| 3 | L6t | OK | |
| 4 | L4t | OK | |
| 5 | L4b | OK | |
| 6 | L5b | OK | |
| 7 | L6b | OK | |
| 8 | L2-3b | OK | |
| 9 | L1b | OK |
| GUI Flange ID | Physical Flange Board | Status |
|---|---|---|
| 0 | 1 (top) | OK |
| 1 | 2 | OK |
| 2 | 3 | OK |
| 3 | 4 (bottom) | OK |
2015
1/28/2015
L1t is now FEB 01
L4b is now FEB 15
There are no FEBs mounted for L6t or L6b.
02/01/2015
L6b is now FEB 04
L6t is now FEB 13
Patch Panel Map
Low voltage:
| DB44 connector | FEB # | FEB # |
|---|---|---|
| P1 | L1t | L2t |
| P2 | L5t | L6t |
| P3 | L4t | L4b |
| P4 | L5b | L6b |
| P5 | L1b | L2b |
High voltage:
| REDEL connector | FEBs |
|---|---|
| 1 | Top half (top connector) |
| 2 | Bottom half (bottom connector) |
Original high voltage GUI to physical hybrid mapping
Reloading PGP card drivers
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./ pgpcard_load
OLD: Take a calibration run with expert SVT GUI
Start the DAQ:
$ cd /u1/software/software_new
...
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.
Test Run SVT Group C Setup
Overview
Content Tools