...
- Open new terminal: sudo putty /dev/ttyUSB0 -serial -sercfg 9600,8,n,1,N
- Commands
- View status: "status"
- Check cooler power: "pwout" (this should be 60. If not, set with "pwout=60")
- Turn cryotel on: "cooler=power"
- Turn cryotel off: "cooler=OFF" (might need to enter this command more than once to actually turn power off)
--------Only applicable for bench testing-------------
Parameters on waveform generator:
- Waveform: Pulsed mode
- Frequency: 200Hz (or anything under 250Hz)
- Pulse Height: 3.3V
- Pulse Offset: 1.65V
- Pulse Width: 1us
- Burst Mode: ON (lately it seems you must have it on to see anything on detector)