Versions Compared

Old Version 1

changes.mady.by.user Curtis, Courtney A.

Saved on

compared with

New Version 2

changes.mady.by.user Curtis, Courtney A.

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Started screen explanations

Table of Contents
typeflat

Navigating The Profile Monitor Screens

For these examples I will be using the LCLS-II OTR11B device in L1B/BC1B location. There are two designs used for the Profile Monitor Devices; A standard device with 1 target, 2 filters, 2 lamps, and 3 motors and the PAL device with 2 target screens, 1 filter, 1 target lamp, and 1 motor.

Main Location Screen

  1. Link to Profile Monitor MATLAB GUI: where you are able to see all of the Profile Monitor Cameras and capture images for the e-Logbook.
  2. Brightness Controls: this is dependent on which chassis the slider controls. If you are not seeing the brightness change when there are multiple brightness options double check which one you are using
    1. In future iterations the brightness bar will be attached to each of the Profile Monitor Device Controls.
    2. PAL device has only the target brightness bar.
  3. Profile Monitor Device Controls: this widget controls and displays the status of the Profile Monitor Device. All sections, other than the indicator light in the top right, have visibility rules for the devices set automatically during IOC start but can be turned on after the fact if needed.
    1. Camera Image and On/Off button: $(DEVICE):CAMTYPE
    2. Target Button: $(DEVICE):TGTINSTALLED
    3. Filter 1: $(DEVICE):FLT1INSTALLED
    4. Filter 2: $(DEVICE):FLT2INSTALLED
    5. Target Lamp: $(DEVICE):TLAMPINSTALLED
    6. Grid Lamp: $(DEVICE):GLAMPINSTALLED
    7. Motor Controls (not visible):$(DEVICE):MTRINSTALLED
    8. Indicator light will be green if the camera is powered (Standard) or has framerate (PAL)
  4. TID Image/PGP/Timing Camera Controls: this screen confirms if the FEB and Camera are communicating, controls camera exposure time, camera trigger delays, camera gain, image mode, trigger mode, image collection, camera setup, chosen triggers and timing. There are some bugs with this screen so if the camera is not behaving appropriately please look though the verification portion of the screen below.

Image Added