...
*Add Example to how to open related display tprTrigger
*Autogen display from DB
*Fixing undefined macros
2)General TPR Setup:
2a) Make sure the MODE PV is set to SC, Link is up and set the Message Delay
...
Example = 112597 nsec BPMS Message Dealy set in Diag0
Set through caput!
2b)Setup TPR Trigger
The Triggers are linked to the firmware by the Firmware Engineer, talk to the Firmware Engineer to find out what is associated with each Trigger and then set meaningful names to each trigger "Desc".
*Change the TWID and TDES to enterable fields → Verify that SYS0 and SYS2 does update with Mode switching
*Allow to view NC and SC displays
$TOOLS/pydm/display/evnt/tprDiag.ui
...
AC Rates are 0.5Hz, 1Hz, 5Hz, 10Hz, 30Hz, 60Hz → To achieve 120Hz INCLUDE TIMESLOT MASK TS3 and 6!
*0.5Hz Please review DB → Should that be there?
Exp Rate → THIS SECTION NEEDS EDITS! Apologies...
...
Seq = # and bit = # & EXCLUDE dest = # this provides the out of time trigger.
3e)Trigger on a SYS BSA Buffer at 1Hz, 10Hz, 100Hz → Control Sequence Setup
...
