...
Drawings are created from CU-ISC and OSC I-DEAS models combining design dimensions with final setup measurements, than they are translated to pdf, dxf and other formats.
CU/ISC 2D DRAWINGS
ACD Tiles position (2D drawings
...
)
Drawings created combining Moiseev-Ylinen and INFN-Pisa Team measurements
...
.
PDF version:
CU-ISC_setup_test_config_ACD_Tiles_position_2D.pdf
DXF version:
...coming
NOTES
see also ACD tiles photos and dimensions at Geometry
THEODOLITE TARGETS-INSTRUMENTS POSITION (2D drawing
...
)
Targets and Instruments distances taken with respect to ISC base plate borders.
CALs distances are measured wrt CsI layers.
IMPORTANT NOTE: Consider that each CsI crystals has a cover 0.75mm thick. This cover thickness must be subtracted to have the exact distances.
At each crystal end there are caps around 5mm thick (see NLR drawings link below)
PDF PDF version:
CU-ISC_Theodolite_TARGETS_POSITION_2D.pdf
NOTES:
CAL CsI crystals drawings can be found here: NRL CALs drawings
CU/ISC 3D DRAWINGS
The following CU/ISC 3D drawings can be viewed (not measured) with Acrobat Reader 7.08.
...