- Todo: Add to JIRA
Can we do the power fanout (Hampus)
- Check power cable (any negative lots for force to insert/remove it)
- If we can make the detector deeper, that would be better but not hard requirement
- Need a clip for the cooling lines
- Light shield not designed
- Side and back panels. Need to have the interface definition
- Installationg procedure
- exploded view of the 1Pix thinking on installation
- Adjust support that hold 1MPIx - make continuous and flush
- Make removable guiding posts
- After rotation, 1MPix in not fully aligned
- Make 1 Mpix support stand for bench assembly
- Make single module bench assembly
- Make the 1MPix suppert as S shape
SparkPix-s GT 2x2
- Mechanical model has been donlowad them
- Boards have been donwloaded
- Then swap them in
- Name sparkPix-rtReadout-90degree assembly
- Check the envelope for the 4MPix
- Envelope is 14" plus shell structure which is bigger than the 286mm
- pipe with ID 5mm, square box in the center will be 10mm
- Add clearance between modules .008"
- Simplify cooling pipe route
- Fix cooling block holes
- We need to define the support structure for the 4MPix
- XPP values
- CXI is 286mm does not fit by a long shot
Overview
Content Tools